back
• Pressure range: 0 to 700 bar
• Accuracy: ± 0,1 % FS
• Heatable pressure port
• Temperature up to +400°C
• Medium: Oil
The pressure calibrator PPS1210/PPS1210L with heatable pressure port allows fast and accurate on-site tests of the mass pressure sensors under operating conditions.
In order to carry out a test, the sensor needs to be screwed into the pressure port. The booster pump is used to generate a pre-pressure. By turning the knob on the screw-type compressor you can easily create pressure up to 700 bar on the screwed-in unit under test. The integrated PID temperature controller allows setting the desired ambient temperature up to +400 °C on the pressure port.
This model requires an external pressure supply to the sensor under test. The output signal must be recorded by an external measurement device (refer to the example in image 3). The measured output signal (Volt, mV or mA) can be evaluated according to the pressure display of the calibrator against the set point corresponding to the pressure.
« previous Productnext Product »
PPS1210 - PPS1210L - heatable Pressure Controller
Article-No.: PPS1210 - PPS1210Lmanufacturer
• Pressure range: 0 to 700 bar
• Accuracy: ± 0,1 % FS
• Heatable pressure port
• Temperature up to +400°C
• Medium: Oil
The pressure calibrator PPS1210/PPS1210L with heatable pressure port allows fast and accurate on-site tests of the mass pressure sensors under operating conditions.
In order to carry out a test, the sensor needs to be screwed into the pressure port. The booster pump is used to generate a pre-pressure. By turning the knob on the screw-type compressor you can easily create pressure up to 700 bar on the screwed-in unit under test. The integrated PID temperature controller allows setting the desired ambient temperature up to +400 °C on the pressure port.
This model requires an external pressure supply to the sensor under test. The output signal must be recorded by an external measurement device (refer to the example in image 3). The measured output signal (Volt, mV or mA) can be evaluated according to the pressure display of the calibrator against the set point corresponding to the pressure.
product images
